F630 Negative Travel Limit Value is Exceeded超过负行程限值

The drive has been provided with a command value that leads to an axis
position outside the negative travel range.
为驱动器提供了一个指向轴的命令值位置在负行程范围之外。

The axis has been stopped and the error reaction "set velocity command value to zero" issued. Bit 2 of P-0-0090,
轴已停止，并发出错误反应“将速度命令值设置为零”。P-0-0090的钻头2，
Travel limit parameter has been set to "Exceeding the travel limit is an error", or a drive control command has been started while the axis limit value is exceeded (e.g. drive-controlled homing).行程限制参数已设置为“超过行程限制是一个错误”，或者在超过轴限制值时启动了驱动控制命令（例如，驱动控制归位）。

Cause:原因：
S-0-0050, Negative position limit value is exceeded.
S-0-0050，超过负位置限值。

Remedial action:补救措施：
1. Check S-0-0050, Negative position limit value
检查S-0-0050，负位置限值
2. Check the controller software limits
检查控制器软件限制
3. Activate the axis after the error reaction
错误反应后激活轴

Procedure:
Clear the error Activate power if it has been de-activated
Move the axis to the permissible working range
清除错误。如果电源已停用，则激活电源将轴移动到允许的工作范围

Note:Only command values that lead back into the permissible working range will be accepted. Any other command value will stop the drive again.
注意：只有返回允许工作范围的命令值才会被接受。任何其他命令值都将再次停止驱动器。